Linear Gauge Sensors Onosoki GS-1713A, GS-1730A, GS-1813A, GS-1830A

Ngày đăng: 09/24/2021 - 792 lượt xem

Giá: Liên hệ

Xuất xứ:
Tình trạng:
Model:
Bảo hành:

Số lượng:

Mua hàng

Hotline:

Hotline: 0365930441

Mô tả sản phẩm
Thông số kỹ thuật
Chi tiết dòng sản phẩm
Tài liệu kỹ thuật

Specifications

Model name Item	GS-1713A	GS-1730A	GS-1813A	GS-1830A
Measurement range	13 mm	30 mm	13 mm	30 mm
Resolution	10 μm		1 μm
Accuracy (at 20 °C)	3 μm	3 μm	2 μm	3 μm
Maximum spindle velocity^*1	1(4) m/s		0.3(1.2) m/s
Measurement force(downward)^*2	1.3 N or less	1.9 N or less	1.3 N or less	1.9 N or less
Number of sliding times (proven in our endurance test)	6.5 million times or more
Protection class (not including connector part)	IP64
Stem diameter	Ø15 mm^+0-0.009
Power supply	4.5 to 5.5 VDC
Power consumption (5 VDC)	120 mA or less
Signal output (5 VDC)	Two-phase square wave, phase difference: 90° ± 20° Output voltage Hi:4.5 V or more / Lo:0.4 V or less
Output impedance	Approx. 22 Ω
Vibration resistance (when the power is off) ^*3	98 m/s² in each of the three axial directions (75 minutes per each), 10 cycles of 10 Hz to150 Hz sweeping
Shock resistance (when the power is off)^*3	980 m/s² in each of direction for each of three axex, three times for each of ±X,Y and Z directions, sine half-wave, pulse duration 6 ms
Operating temperature range	0 to +40 °C
Storage temperature range	-10 to +55 °C
Cable length	Approx. 1.9 m
Weight (including cable, connector)	Approx. 250 g	Approx. 310 g	Approx. 250 g	Approx. 310 g
Accessories	Instruction manual, spanner

*1. When used with Ono Sokki's Gauge Counter. The values within parentheses () is the maximum spindle velocity used with the DG-4140/DG-4190/DG-5100/DG-3000.
*2. An attachment may not return completely if it is facing upwards.

*3 Vibration/shock resistance values described in above are not guaranteed during measurement operation.

• Disconnected or modified signal cable is not applicable to CE marking.

NOTE:Please check an attaching portion (material, grounding etc.) before you install the New GS series. If the New GS series is installed in a metallic portion that is not grounded, it might cause blowout of a fuse or cable damage because of a potential difference that might be produced between a counter side chassis and a sensor side chassis.