|
Plating |
Single layers |
Multilayer |
Alloy |
Wire |
|
e.g. Cr,Ni,Cu,Zn,Sn,Ag,Au,Cd,Co,Pb |
e.g. Cr/Ni/Cu |
e.g. NiP,ZnNi,SnZn,SnPb |
e.g.Cu,Ag,Sn,Zn,Ni |
|
Substrate |
Metallic |
Non-metallic |
Wire |
e.g. steel, copper and its alloy,
aluminium, die-casting zinc |
e.g. plastic(ABS), ceramics |
e.g. steel, copper and its alloy |
|
Range |
0.03～300μm |
|
best thickness range: 0.03～50um, over 50um, the error will gradually increase |
|
Resolution |
0.01um |
|
Reproducibility |
≤5% |
|
Indication Error |
≤10% |
|
Potential Range |
0～3000mv |
|
Potential Accuracy |
0.01mv |
|
Gasket |
Wire test: no gasket required.
Plane test: need to purchase additional gasket and STD07 test stand |
|
Wire Test |
The thickness of coating on wire or cylinder with diameter of 0.1-4mm can be measured;
Direct reading without conversion;
STD07 test stand shall be purchased for wire with diameter above 4mm and plane sample. |
|
Test Stand |
standard: STD-W Wire Stand
choose: STD07 Test Stand, STD19 Test Stand |
|
Calibration |
the thickness can be calibrated by the calibration plate.
Calibration plates need to be ordered separately. |
|
Printer |
embedded thermal printer |
|
Print Contents |
plating type,thickness,average,maximum,minimum,standard deviation,coefficient of variation,date |
|
Display |
126 * 64 dot matrix LCD |
|
Data Storage |
/ |
|
Shortcut Key |
four shortcut key for single or multi layer coating / substrate combination selection |
|
Cell Voltage |
display with thickness value |
|
Suspend Test |
for thick coatings, the test can be stopped at any time,
and can be continued after changing the electrolyte |
|
Version |
Ver 2.0 |
|
Power |
AC 220V，AC110~ 220V |
|
Size |
220*195*120（mm) |